Q-NOTE QN-7000HX Spécifications télécharger pdf (Page 32)

28 SMS 7000 Release Notes

Version 6.41

Program MCPU Software

This is to be used when upgrading from versions 5.x and 6.x only.

Application software version 6.41 must be loaded into MCPU FLASH for

systems updating from 5.x and 6.x to work properly.

You must remove the redundant MCPU from the frame while booting from

the Ethernet or SLIP device. You will perform Step 4 for the primary MCPU

and then repeat it for any redundant MCPU. The redundant MCPU will

use slightly different names and IP addresses. These are indicated in brack-

ets [ ] to the right of the primary MCPU entries below.

You must be at the DOS C: prompt to complete the following steps:

1. At the PC, run the ﬁle transfer protocol daemon (FTPD) on the PC:

C:\> CD \SMS7000

C:\SMS7000> FTPD -d

Note The PC NFS FTPD program fails to run if the ﬁle FTPD.LCK ex-

ists in the NFS install directory. If this ﬁle exists, execute the fol-

lowing commands to remove it:

C:\> CD \NFS

C:\NFS> ATTRIB -R FTPD.LCK

C:\NFS> DEL FTPD.LCK

C:\NFS> CD \SMS7000

2. Change the Boot Device to the PC

Insert the primary MCPU only (in the left or main MCPU slot) and

quickly interrupt the boot process by repeatedly striking the

RETURN

key at the terminal keyboard. This is a one to two second operation.

(When you do the Back-up MCPU, place it in the right or redundant

slot and remove the primary MCPU.)

Note The PC-NFS ping utility will not work when the Series 7000 is at

the boot prompt.

You should see the 7000 BOOT prompt:

SMS7000 Boot>

If not; try again.

You may view the boot parameters by using the p (lower case only)

command:

SMS7000 Boot> p

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 43 44

Pas de commentaire

Q-NOTE QN-7000HX Spécifications Page 32