Q-NOTE QN-7000HX Spécifications télécharger pdf (Page 39)

SMS 7000 Release Notes 35

Hardware, Firmware, and Software Installation

Loading EDP Panel Software Into Nonvolatile Memory

The Eight Destination Paging (EDP) panel software is not loaded as

part of either Option 1 or Option 2.

To load EDP software:

● Make sure there is enough room (200000 bytes) in ﬂash memory for

this software.

● To check, type

C:\sms7000> dir

from the diagnostic terminal to list ﬁles;

● To make space, remove unneeded control panel mot ﬁles from ﬂash

memory.

For example:

C:\sms7000. del mco.mot

will delete the MCO panel ﬁll (you may wish to keep ﬂ.mot, which

is the node controller ﬁle)

● From the SMS7000 directory of the PC, type:

C:\sms7000> edpload sms7000[edpload sms7000b]

Program Redundant MCPU

This is to be used when upgrading from versions 5.x and 6.x only.

Repeat Program MCPU Software on page 28 for the Backup MCPU.

The redundant MCPU will use slightly different names and IP addresses.

These are indicated in brackets [ ] to the right of the primary MCPU entries.

Reload and Edit Conﬁguration File

This is to be used when upgrading from all versions.

Using the Windows Conﬁguration Editor (GUI), open and download your

conﬁguration and edit the Coprocessor Conﬁguration.

Version 6.41 relies on the conﬁguration GUI to maintain the coprocessor

conﬁguration.

■ For Version 4.0 systems, a FLASH DISK ﬁle named COPROC.CFG con-

taining this information; the ﬁle was manipulated using the system di-

agnostic commands, slot and/or pg.

■ For Version 6.1 and later, the COPROC.CFG ﬁle is no longer used and

may be removed using the Diagnostic Terminal with the

SMS7000>del “coproc.cfg” command. The conﬁguration GUI

provides the interface to manipulate these records.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44

Pas de commentaire

Q-NOTE QN-7000HX Spécifications Page 39