Q-NOTE QN-7000HX Guide de l'utilisateur télécharger pdf (Page 50)

Open Problem Reports and Feature Exceptions

page 50 OmniSwitch 6600/7000/8800—Release 5.1.6.R02

PR 73953

With an LPS (Learned Port Security) configuration is set only to allow a specific MAC on a port, and

when the port receives non-authorized traffic (ARP requests), the MAC information shows that the unau-

thorized host is in a "filtering" state; therefore all traffic should be filtered. However, the ARP table learns

the ARP entry for the filtered host. ARPs should not be learned for "filtered" hosts.

Workaround: There is no known workaround at this time.

Link Aggregation (including OmniChannel)

Feature Exceptions

• OS7000: Please refer to the Link Aggregation chapters of the OmniSwitch 7700/7800/8800 Network

Configuration Guide, which include instructions for optimizing first-generation Network Interface

modules for link aggregation.

• OS6600: Static link aggregation: A single aggregate group can have 16 ports in a stack as long as no

more than 8 ports are added on a single switch. The ports must be assigned sequentially and the first

port configured must begin with port number 1, 9, 17, or 25 on an OS6624 or 1, 9, 17, 25, 33, 41, 49 or

51 on an OS6648. The ports on different switches (NIs) can be in the same aggregate group. The ports

should be with the same speed. The flow of traffic will be such that it goes out from the closest link-

aggregate port.

• For more information, please contact Customer Support via email at support@ind.alcatel.com.

Problem Reports

PR 61641

An OS7000 series switch with static link aggregation configured and connected to several simple ports

could lock up if the flooding traffic is immediately opened before configuring the necessary opposite

aggregate on the remote side.

Workaround: Directly create the objects in an active state. Thereby, bypassing this problem by previ-

ously configuring together both sides of the static aggregates, with aggregation set as "disable". Therefore,

the "admin state" must be set to "disable" just after the creation. When the whole configuration is ready,

set the admin state to "enable", as it is by default. There is also the possibility of setting down/up ports.

Therefore interfaces could also be set admin "down/up" before everything is ready.

PR 67598

Link aggregate on gigabit uplinks occasionally fails to load balance traffic on an OS6624/6648 series

switch.

Workaround: There is no known workaround at this time.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 114 115

Pas de commentaire

Q-NOTE QN-7000HX Guide de l'utilisateur Page 50