Q-NOTE QN-7000HX Guide de l'utilisateur télécharger pdf (Page 88)

Open Problem Reports and Feature Exceptions

page 88 OmniSwitch 6600/7000/8800—Release 5.1.6.R02

DVMRP

Problem Reports

PR 56990

Tunnel destined flows are not displayed in the show ip multicast forwarding CLI command on an

OS7000 series switch. There is simply no room left on the line to display.

Workaround: Use the show ip mroute-next-hop CLI command instead, to display tunnel endpoint infor-

mation.

PR 90878

On an OS7000 series switch, by administratively disabling a DVMRP-configured IP interface via the

command "ip interface <ifname> admin disable", and then re-enabling that same IP interface via ip

interface <ifname> admin enable, DVMRP is not automatically re-enabled.

Workaround: To get DVMRP operational again on that specific interface, re-issue the ip dvmrp inter-

face <ifname> command. (This is the command initially used to configure DVMRP on the interface.) If

the IP interface becomes disabled due to other events, such as disabling ports, the DVMRP command does

not need to be re-issued.

Multicast Routing

Problem Reports

PR 55446

Multicast routing does not handle large multicast bursty traffic on an OS7000 series switch.

Workaround: There is no known workaround at this time.

PR 79306

Multicast streams may be momentarily disrupted during NI insertion or removal.

Workaround: This condition is temporary and all flows will resume after a few seconds.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 114 115

Pas de commentaire

Q-NOTE QN-7000HX Guide de l'utilisateur Page 88