Q-NOTE QN-7000HX Guide de l'utilisateur télécharger pdf (Page 77)

Open Problem Reports and Feature Exceptions

OmniSwitch 6600/7000/8800—Release 5.1.6.R02 page 77

PR 91850

IPX statistics are not correct with WebView or SNMP.

Workaround: A show ipx traffic command needs to be executed on CLI, so that the statistics can be

retrieved from the NIs.

PR 91979

IPX network address cannot be set through SNMP.

Workaround: Use either CLI or WebView to set IPX network address.

NTP Client

Feature Exceptions

• NTP is not supported in Server mode.

Problem Reports

PR 72478

A preferred (NTP) server does not synchronize the client before a non-preferred server.

Workaround: There is no known workaround at this time.

PR 72889

It may take about 12 minutes for the NTP client to readjust its internal clock when the offset is small.

The time update is triggered by the NTP algorithm itself. In general, if the offset is larger than 128 milli-

seconds continuously for 900 seconds (15 minutes), a time update is done. This design prevents excessive

time updates by using a threshold to debounce timestamp data received.

Workaround: There is no known workaround at this time.

Server Load Balancing (SLB)

Problem Reports

PR 60561

If an SLB cluster is configured with "failover" as the distribution algorithm, and when a new server in the

cluster comes UP, then the connections already established with a less priority server are not re-estab-

lished through the new one (no automatic switchback) on an OS7000 series switch.

Workaround: There is no known workaround at this time.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 114 115

Pas de commentaire

Q-NOTE QN-7000HX Guide de l'utilisateur Page 77